Categories
Price Range
Manufacturers
Themes
    Home > Products > 008- Motor, Servo, Fan, Chassis & Driver > DRV8825 Stepper Motor Driver - Module 3D Printer StepStick
    DRV8825 Stepper Motor Driver - Module 3D Printer StepStick
    enlarge

    1 Sold

    DRV8825 Stepper Motor Driver - Module 3D Printer StepStick

    Rating: 0 out of 100 - based on 0 review(s) | Write Review |
    RM10.00  
    Item details
    SKU: 008-025

    Stock: Stock available

    Brand: 008- Motor, Servo, Fan, Chassis & Driver
      Share This   Add To Facebook   Add To MySpace   

    DRV8825 Stepper Motor Driver - Module 3D Printer StepStick

    Description:

    The module has an interface pinout is almost the same with A4988 stepper motor drive carrier, so that it can be used as a higher performance in a pull-down menu the plates replaced in many applications.

    DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step).

    It uses 8.2 - 45V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).

    Feature:

    • Simple step and direction control interface
    • The interface can connect directly with 3.3V and 5V systems
    • Support over-temperature thermal shutdown, over-current shutdown and under-voltage lockout
    • Support short-to-ground and shorted-load protection
    • Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
    • 4-layer, 2 oz copper PCB for improved heat dissipation
    • Adjustable current control support you to set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
    • Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
    • 45V maximum supply voltage
    • Built-in regulator (needed external logic voltage supply)