Price Range
    Home > Products > 008a- Motor Driver > Stepper Motor Driver DRV8825 Module 3D Printer StepStick
    Stepper Motor Driver DRV8825 Module 3D Printer StepStick

    Stepper Motor Driver DRV8825 Module 3D Printer StepStick

    Rating: 0 out of 100 - based on 0 review(s) | Write Review |
    Item details
    SKU: 008-025

    Stock: Stock available

    Brand: 008- Motor, Servo, Fan, Chassis & Driver
      Share This   Add To Facebook   Add To MySpace   

    DRV8825 Stepper Motor Driver - Module 3D Printer StepStick


    + The module has an interface pinout is almost the same with A4988 stepper motor drive carrier, so that it can be used as a higher performance in a pull-down menu the plates replaced in many applications.

    + DRV8825 features an adjustable current limit, overcurrent and overtemperature protection, six micro-resolution (down 1/32-step).

    + It uses 8.2 - 45V, can provide up to about 1.5 per phase no heat sink or forced air flow (rated up to 2.2 per volume sufficient additional cooling).

    + Simple step and direction control interface
    + The interface can connect directly with 3.3V and 5V systems
    + Support over-temperature thermal shutdown, over-current shutdown and under-voltage lockout
    + Support short-to-ground and shorted-load protection
    + Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step+ 4-layer, 2 oz copper PCB for improved heat dissipation
    + Adjustable current control support you to set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor’s rated voltage to achieve higher step rates
    + Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
    + 45V maximum supply voltage
    + Built-in regulator (needed external logic voltage supply)